|
| | Seven easy steps on how to install Flex / Sound Guard. You can Install Flex-Guard over directly over ceramic tile, marble, granite, vinyl tile, wood and most secure sub-floors. Saving time and money on rip out cost. Note: Your sub-floor must be clean. Return To Order Page. Click Here. | |  | Step 1: Unroll the Flex-Guard and cut to the length you want to install. A utility knife makes it easy. (Hint) If you use a chalk line to line up the edge of the Flex-Guard with as you unroll it, it would make it easier and faster. |
 | Step 2: Snapping a chalk line for the edge of the Flex-Guard will speed installation along. |
| Step 3: Lay the Flex-Guard exactly where you want it to stick, then pull over the end, and gently cut thru just the clear release sheeting. |
 | Step 4: Now pull off the end piece of the clear release sheet that you just cut. |
| Step 5:Lay the exposed end down and adhere it to the sub-floor. |
| Step 6: Roll the Flex-Guard back up to where it is adhered to the sub-floor. Grab the corner of the release paper and pull them towards you. It will unroll as you pull it. It should be following your chalk line. |
| Step 7: Now take the flat side of a trowel or a floor roller and apply a little pressure to aid in adhering to the sub-floor. Start in the middle and work your way toward the edges. Now your ready to set tile! |
Return To Order Page. Click Here. |